Reflective for Bin-Picking

SSP-S200 Series

  • Retroreflective and Diffuse reflective mode switching
    It is possible to switch between Retroreflective and Diffuse reflective modes by flipping an Inner switch.
    You can select either Retroreflective or Diffuse reflective mode depending on the detecting distance for use.
  • Super thin body at only 13mm thick with sturdy metal case
    The metal case protects against impacts that may occur when an item, which you are taking out from a shelve, hits the case. Also, its space-saving thinness means the sensor does not become an obstacle during work.
  • Easy-to-see large Job indicator
    On the side of the body, there are two large-sized, highintensity green LED Job indicators which are easy to see.
  • NPN/PNP dual output
    You can select either NPN or PNP output with an inner switch of the sensor, which will contribute to reducing your stock of sensors.
  • Fault indicator
    If you take out the wrong item from a shelve, red lights of the Fault indicator flash on and off, letting you know the item is wrong.
  • Initial sensitivity setting function
    When you turn on the power after selecting either Retroreflective or Diffuse reflective mode, the optimal sensitivity is automatically set by the initial sensitivity setting function.
Contact us about this series

SSP-S200 Series

Model Detecting width Number of beams Output mode Wiring Protective structure  
SSP-S204R 100mm 4 NPN/PNP Attached cable IP62
Contact
SSP-S204R-PJ 100mm 4 NPN/PNP M12 Connector IP62
Contact
SSP-S208R 225mm 8 NPN/PNP Attached cable IP62
Contact
SSP-S208R-PJ 225mm 8 NPN/PNP M12 Connector IP62
Contact

More Info

SSP-S204R
SSP-S208R

SSP-S204R-PJ
SSP-S208R-PJ

Protective cover
SSP-BF

Attached cable type

With the mode selector switch, you can select for job indicator input and NPN/PNP type Reciever output.

Cable with connector type (-PJ)

With the mode selector switch, you can select for job indicator input and NPN/PNP type Reciever output.

Connection

  • About Wiring
    When expanding the wiring, use cables with 0.5 mm2 or more. The length of expansion has to be 100m or shorter for the transmitter and the receiver each.