| Model | Detecting width | Optical axis interval | Detection object | Output mode | Protective structure | |
|---|---|---|---|---|---|---|
| SSC-T801 | 50mm | 5.55mm | Opaque φ6mm or more | NPN | IP67 | |
| SSC-T801PN | 50mm | 5.55mm | Opaque φ6mm or more | PNP | IP67 | |
| SSC-T802 | 50mm | 5.55mm | Opaque φ8mm or more | NPN | IP67 | |
| SSC-T802PN | 50mm | 5.55mm | Opaque φ8mm or more | PNP | IP67 | |
| SSC-T804 | 50mm | 12.5mm | Opaque φ15mm or more | NPN | IP67 | |
| SSC-T804PN | 50mm | 12.5mm | Opaque φ15mm or more | PNP | IP67 | |
| SSC-T805 | 50mm | 12.5mm | Opaque φ12.5mm or more | NPN | IP67 | |
| SSC-T805PN | 50mm | 12.5mm | Opaque φ12.5mm or more | PNP | IP67 | |
| SSC-T810 | 100mm | 11mm | Opaque φ11mm or more | NPN | IP67 | |
| SSC-T810PN | 100mm | 11mm | Opaque φ11mm or more | PNP | IP67 | |
| SSC-T815 | 100mm | 20mm | Opaque φ20mm or more | NPN | IP67 | |
| SSC-T815PN | 100mm | 20mm | Opaque φ20mm or more | PNP | IP67 | |
| SSC-T830 | 100mm | 11mm | Opaque φ13mm or more | NPN | IP67 | |
| SSC-T830PN | 100mm | 11mm | Opaque φ13mm or more | PNP | IP67 | |
| SSC-T835 | 100mm | 20mm | Opaque φ22mm or more | NPN | IP67 | |
| SSC-T835PN | 100mm | 20mm | Opaque φ22mm or more | PNP | IP67 | |
| SSC-T850 | 150mm | 16.6mm | Opaque φ17mm or more | NPN | IP67 | |
| SSC-T850PN | 150mm | 16.6mm | Opaque φ17mm or more | PNP | IP67 |
SSC-T800 makes a sequential scan of a two dimensional array formed by each transmitter and the whole set of corresponding receivers.
This method of scanning creates a high-density detection net between the transmitter and the receiver. Thin pipe, tape or name cards that pass through conventional light curtains can be reliably detected.
The figure on the right shows a model with six light axes. The number of light axes depends on the model.
When installing the main unit of the sensor, the tightening torque has to be 0.6N m or less.
When installing the main unit of the sensor, the tightening torque has to be 0.6N m or less.
When installing the main unit of the sensor, the tightening torque has to be 0.6N m or less.
When installing the main unit of the sensor, the tightening torque has to be 0.6N m or less.